INTERCOM SIGNALING MODE

INTERCOM SIGNALING MODE
Description
Each iPECS Phone can select the signaling mode used for incoming ICM calls while the station is idle. There are three signaling modes available.
H - Call announcing with Handsfree answerback:
When an ICM call is received, the user receives splash tone followed by the ICM caller’s voice. The user may respond to the caller without the need to ‘Lift the handset’ or ‘press the [SPEAKER] button’.
P - Call announcing with Privacy:
When an ICM call is received, the user receives splash tone followed by the ICM caller’s voice. To respond the user must lift the handset or press the [SPEAKER] button.
T - Tone ringing:
An ICM call will cause the iPECS Phone to provide audible ICM ring tone. The user must lift the handset or press [SPEAKER] to answer. An SLT always functions in the Tone ring mode.
Operation iPECS Phone To change ICM Signaling Mode
1. Press [PGM] button, the [SPEAKER] button LED lights steady.
2. Dial Station User Program code ‘13’, confirmation tone is received.
3. Dial the desired ICM Signaling Mode code (‘1’ for H, ‘2’ for T or ‘3’ for P).
4. Press the [SAVE] button.
Conditions
1. Message Wait, Callback, Call Forward and Attendant Override will ring in the tone mode, regardless of ICM Signaling Mode selected by the user.
2. The ICM signaling Mode Selection does not affect Page announcements.
3. The default ICM Signaling mode is Tone ring and the active mode is stored in battery- protected memory.