Event

Evt:210-YYYZ S4 Loopback test YYY on Trunk Cartridge Z has started
Evt:211-YYYZ S4 Loopback test YYY on Trunk Cartridge Z has stopped
Evt:220-3546 S4 the Sys admin log has been cleared by the DN (3546 in this case)
Evt:221-3546 S4 the Sys test log has been cleared by the DN (3546 in this case)
Evt:222-3546 S5 the DN (3546 in this case) enters the debugging facility that is password protected
Evt:255 S9 administered mode is not supported by the cartridge plugged into the slot
Evt:260-0302 S8 the ICS takes the access line on port 0302 out of service because no current was detected
Evt:261-0302 S1 the access line on port 0302 is returned to service after current was detected (see Evt:260)
Evt:263-302 S8 the ICS takes the E&M line on port 302 out of service because the far end did not respond to a disconnect signal
Evt:264-302 S1 the E&M line on port 302 is returned to service after the far end finally responded to a disconnect signal (see Evt:263)
Evt:265-302 S7 the E&M line on port 302 did not receive an expected wink signal or delay dial signal from the far end
Evt:267 S9 a data module has been disconnected
Evt:268-07 S8 Dialing filter 07 has lost data due to a fault in the system memory